ITEM REMARKS PAGE
Engine stop switch Ensure proper operation page 29
Air filter, pre-filter Inspect, clean page 91
Headlamp Check operation page 27
Brake light/taillight Check operation
-
Riding gear
Wear approved helmet,
goggles, and protective
clothing
page 11
Winch (if equipped) Inspect cable and switch page 63
Grass and leaves Remove grass, leaves, foreign
matter, and other flammable
material or debris, especially
near the exhaust system.
-
STARTING THE ENGINE
1. Position the vehicle on a level surface outdoors or in a well- ventilated area.
2. Place the transmission in PARK.
3. Lock the parking brake.
TIP
The starter interlock will prevent the engine from starting if the brake is not
engaged.
4. Sit on the vehicle and move the engine stop switch to RUN.
TIP
Do not press the throttle while starting the engine.
5. Turn the ignition key past the ON position to engage the starter. Activate the
starter for a maximum of five seconds, releasing the key when the engine
starts.
6. If the engine does not start, return the key to the OFF position and wait five
seconds before attempting to start again. Activate the starter for another five
seconds if necessary. Repeat this procedure until the engine starts.
58
OPERATION
To Next Page
Loading...
