92
SPECIAL PROCEDURES
Launching The Watercraft
Launching In Shallow Water
1. Never operate the watercraft in less than 2 feet (60 cm) of water.
Guide the watercraft to an area that is deep enough, bounce the rear
of the watercraft up and down t o flush out the pump, then board it
from the side or rear.
2. Attach the lanyard lock plate t o the engine stop switch and fasten
the lanyard wrist band to your left wrist or PFD.
3. Grasp the right handlebar grip. With both feet on the footrests, start
the engine, and ease the throttle open.
Before launching be aware of weather conditions; make sure
there are no boats, swimmers or other obstructions nearby.
Failure to be aware of these details could cause an accident,
resulting in severe injury or death.
WARNING
To Next Page
Loading...
Need help?
General