Polaris Virage TX 2000 Service Manual

MAINTENANCEn"UNE UP
Cable Adjustments
Steering Cable Adjustment
1. Open front door compartment on watercraft. Open
tool kit panel in order to access steering assembly.
2. Locate hole at the base of the steering shaft mount.
Align handlebars so that the hole in the steering
shaft aligns with the hole in the mount. Insert a 1/8"
dowel or drill bit into locking hole. The handlebars
are now locked in.
Insert drill bit or dowel into hole to lock
steerina in center position.
3. Place a straight edge across horizontal center line
of steering nozzle or trim nozzle. NOTE: The trim
nozzle mounting bolts can be used as a reference
for the center line on models with Quick Trim.
See III. 2.
Rear View Of Pump Nozzle
Place straight edge across horizontal
center line of steering nozzle or trim
nozzle.
III. 2
4. Measure distance from straight edge to hull on left
and right side. Be sure to measure at right angles to
the straight edge and at equal distances from the
nozzle. The distance at "X" should be equal when
handlebars are straight.
See III. 3.
Straight Edge
Distance should be equal at "X"
3/00
2.22
Polaris Sales Inc.

Polaris Virage TX 2000 Specifications

General

Brand	Polaris
Model	Virage TX 2000
Category	Boat
Language	English