Polaris Virage TX 2000 Service Manual

MAINTENANCE/TUNE UP
Fuel System
IMPORTANT!
2. Turn off fuel valve (if applicable) or remove battery
ground cable.
3. Wrap a shop towel around top of bowl.
4. Remove bowl slowly by turning counterclockwise.
Take care not to spill fuel while removing. Wipe up
spills immediately with a shop cloth. Dispose of fuel
properly and follow all gasoline handling precautions
found on page 2.26.
5. Clean and inspect all parts. Replace O-rings if worn,
damaged or deteriorated. Install O-ring on bowl.
6. Reinstall separator bowl taking care that the O-Ring is
not damaged and in the proper place.
7. Hand tighten securely. Turn fuel valve on, start engine
momentarily and check carefully for fuel leaks around
bowl.
Never operate the engine for more than 15 seconds with
out cooling water. Severe engine damage may occur from
overheating.
Polaris Sales Inc.
2.27
3/00

Polaris Virage TX 2000 Specifications

General

Brand	Polaris
Model	Virage TX 2000
Category	Boat
Language	English