Polaris Virage TX 2000 Service Manual

MAINTENANCE/TUNE UP
Fuel System
Fuel Lines/Vent Lines
1. Check fuel lines and vent lines for signs of wear,
deterioration, damage or leakage. Replace if
necessary. Insure that clamps are tight.
2. Be sure all lines are routed properly and secured with
cable ties away from any moving parts.
Make sure lines are not kinked or pinched.
Fuel Filter
The fuel filter should be replaced annually or whenever
sediment is visible in the filter.
1. Loosen line clamps at both ends of filter.
2. Remove fuel lines from filter.
3. Install new filter with arrow pointed in direction of fuel
flow.
4. Re-install and tighten clamps on fuel line.
5. Start engine and inspect for leaks.
Never operate the engine for more than 15 seconds with
out cooling water. Severe engine damage may occur from
overheating.
Water Separating Filter - Genesis FFI™
The water separating filter on the Genesis FFI ™ requires
no maintenance.
Arrow Indicates
Direction of Flow
3/00
2.28
Polaris Sales Inc.

Polaris Virage TX 2000 Specifications

General

Brand	Polaris
Model	Virage TX 2000
Category	Boat
Language	English