Electrical Systems
7.54
Reverse Gate in Forward = Up (Press bilge pump and fwd button until reverse motor stops)
PIN (E) PIN (A) PIN (C) PIN (D) PIN (B) PIN (F)
PIN (E) Motor Open Motor Open Closed
PIN (A) Open Closed Open Motor
PIN (C) Open Open Open
PIN (D) Open Motor
PIN (F) Open
Reverse Gate in Neutral = in the middle (Re-connect reverse motor temporarily to move rev. gate)
PIN (E) PIN (A) PIN (C) PIN (D) PIN (B) PIN (F)
PIN (E) Open Open Open Closed Open
PIN (A) Motor Closed Closed Motor
PIN (C) Motor Open Closed
PIN (D) Open Motor
PIN (F) Open
Reverse Gate in Reverse = Down (Re-connect reverse motor temporarily to move rev. gate)
PIN (E) PIN (A) PIN (C) PIN (D) PIN (B) PIN (F)
PIN (E) Closed Motor Open Closed Motor
PIN (A) Motor Open Closed Motor
PIN (C) Open Motor Closed
PIN (D) Open Open
PIN (F) Motor
* Procedure for 2002 models.
Forward
Switch
Sync.
Switch
Reverse
Switch
Work through the continuity tables below to
find fault with the reverse motor / limit switch
assembly. The three possible meter reading
are:
1. Open (O.L.)
2. Closed (0-.1.58)
3. Motor winding resistance (0.5-6.08)
Push the bilge pump button along with
the FWD or REV buttons to change the
position of the reverse gate when the en-
gine is not running. Visually inspect the
reverse gate position. The MFI may not
indicate reverse gate position during this
test. Cycle the reverse gate following this
test to reset MFI gauge.
Male Side of Reverse Motor Connec tor
REVERSE MOTOR ASSEMBLY TEST*
A
F
BLU/W GRY/R GRN/W BLU/W
BLACK GRN/W
BCD E
To Next Page
Loading...