Fuel Injection System
8.2
DIt Service Specification s
Fuel System Pressure
20-30 psi (138-207 kPa)
Injector Unit Resistance
1.00 W
Spark Plug Lead Resistance
450 - 650 W
Ignition Coil Primary Resistance
0.05 - 0.15 W
Ignition Coil Secondary Resistance
225 - 325 W
Crankshaft Position Sensor Resistance
200 W (Maximum)
Air Temperature Sensor Resistance@ 77° F(25° C)
990-1010 W
Water Temperature Sensor Resistance@ 77° F(25° C)
985 - 1015 W
12 Volt Stator Winding Resistance
(Pins: 1 and 12 / 2 an d 11)
0.1 - 0.3 W
45 Volt Stator Winding Resistance
(Pins: 3 and 10 / 4 and 9 / 5 and 8)
0.3 - 0.5 W
Stator Pins: 1 -- 12 (Each) to Ground
O.L.
Stator Cranking Voltage (Approximate)
(Wire colors associated with Pins located on wiring diagrams.)
Pins:
1 and 12 7Vac
2 and 1 1 7Vac
3 and 10 5Vac
4and9 5Vac
5and8 5Vac
Throttle Position Sensor / 1999, 2000, and 2001
(Between A and C)
More Than 3000 W
Throttle Position Sensor -- 2002 (Hall Effect)
4.70 Vdc ± 05 Vdc @ 85°
Throttle Opening (Use throttle
flipper)
Approximately .350 Vdc closed.
Water Injection Solenoid (Virage i Only)
Test function with Diagnostic
Software
Resistance= 29--39 W
To Next Page
Loading...