Maintenance
2.24
Fuel System -- Continued
Carburetor Air Intake
1. Remove nuts and washers, and remove each air
intake. Cover carburetor with a clean shop towel to
prevent foreign material from entering.
2. Clean element with high flash point solvent, followed
by hot soapy water .
3. Rinse in clear water and dry thoroughly using low
pressure air.
CAUTION:
Wear safety glasses when using compressed air to avoid
injury to eyes.
4. Reinstall air intakes and tighten clamps securely.
All 700cc Engines
All 777cc and 1200cc Engines
To Next Page
Loading...