Downloaded from Projector.com
16
1
Press the MAGNIFY
+
button.
• The center part of the image will be displayed magnified approximately 2x.
2
Press the MAGNIFY
+
bu t t o n .
• When this button is pressed, the image will be displayed even larger.
3
Press the MAGNIFY
–
button.
• When this button is pressed, the image will be displayed even smaller.
4
Press the POSITION button.
5
Press the DISK PAD up, down, left and right buttons.
• The magnified area will move in accordance with the button pressed.
6
Press the MAGNIFY OFF button.
Magnify function
Changing the magnification ratio
Moving the display area
Returning to normal display
1,2
3
5
4
6
Part of an image can be displayed magnified.
(refer to page 10)
Basic operations (continued)
• When there is no video signal input, Magnify is not effective when the video signal input is
outside the sync range.
• The magnify function will be cancelled when the input select button is pressed or the display
mode of the PC being used for display is changed.
•
The Magnify function will be cancelled after the operations such as “AUTO”, “KEYSTONE”.
To Next Page
Loading...
Need help?
General
