ENGLISH
17
Chapter 2 Installing the LCD TV
METHOD A:
Use a supplied antenna cable to connect the NTSC signal to the LCD TV’s TV CABLE
terminal.
METHOD B:
Use a supplied antenna cable to connect the ATSC signal to the LCD TV’s
HDTV AIR terminal.
Connect the AC power cord at the back of the TV and connect the power cord to wall
outlet.
Press the button on the remote to turn on the LCD TV.
Always disconnect the LCD TV from the main voltage when the LCD TV will not be used for
a long period of time. The POWER button on the front panel is only used for switching the
LCD TV into standby, it does not disconnect the device from the main voltage. To
completely disconnect the main voltage, please remove the power plug from the socket.
Press the Input button on the remote to
display the Input List. Use the ▲► buttons to
select TV( METHOD A), or HDTV (METHOD
B), and press the OK button.
TV
CABLE
HDTV
AIR
VHF/UHF IN
A
B
TV
CABLE
HDTV
AIR
VHF/UHF IN
Input
TV(CABLE/AIR)
HDTV (CABLE/AIR)
VIDEO1 (SIDE)
VIDEO2 (REAR)
VIDEO3 (S-VIDEO)
VIDEO4 (YPbPr1)
VIDEO5 (YPbPr2)
VIDEO6 (HDMI)
COMPUTER (VGA)
This TV is equipped with a safety fuse. In the event of an electrical storm or power outage the
safety fuse is designed to protect your TV. If your TV has no power, check the fuse by prying
the cover off, following the illustration below. If the fuse is blown, visit your local hardware
store and ask for a 4A 250V - 5x20mm Time Lag Fuse (Slow Blow) to replace the fuse.
4A 250V
5x20mm
Fuse
Back of TV
Firm Plastic Prying Tool D
(Using a metal tool may cause shock)
NOTE: Unplug the AC power cord from the back of your TV before removing the fuse.
To Next Page
Loading...
Need help?
General