Jammed metal cap:
If the
negative (and metal clip)
cannot be removed from the
holder as described above,
you can disassemble the
holder as follows:
a Move the control arm to L(?).
b Insert a small flat-head
screwdriver into the slot
below the side clip, and twist
it to pry off the clip (21).
Remove both side clips.
c Tilt the back panel up, then
remove it from the film holder
(22). Remove the jammed
cap and negative.
d To replace the back panel,
insert the end of the panel
under the lip of the roller
cover (23), then lower the
panel into position.
e Hold the back panel in
position, and replace the side
clips.
Metal cap and envelope
misaligned:
If mishandled,
the envelope and the metal
clip may become misaligned
(24). If the metal clip and
tape on the back of the
envelope are not parallel, tap
the length of the cap lightly
against a flat, solid surface.
19 Warranty
Your Polaroid 545 Pro Film
Holder has been thoroughly
tested and inspected before
shipment. All parts are
guaranteed against defects in
materials and workmanship
for one full year from the date
of original purchase. During
this period, any such defects
will be remedied by Polaroid
Corporation without charge,
except for transportation
costs.
Damage resulting from
normal wear, mishandling or
accident will be promptly
repaired at a reasonable
charge. To make returns pack
the holder carefully in it’s
original shipping carton or
other sturdy container with
plenty of padding and ship it
prepaid to your nearest
Polaroid Office (see list on
back page).
12 English
To Next Page
Loading...
Need help?
General
