600/600 SE Camera User Guide
4
Attaching the lens (Model 600 SE only)
Insert the lens, aligning the red dot on the lens
barrel with the red dot on the camera body
(4). Turn the lens clockwise until the red dot is
directly on top and the lens locks in place.
Screw the end of the cable release into the
cable release socket on the lens (5).
Before removing a lens, unscrew the cable
release from its socket on the lens and hang
it on the cable release holder on the hand
grip (6). (The cable release is permanently
fixed to the handle and cannot be removed.)
If there is film in the camera, be sure the dark
slide is inserted before removing the lens.
To detach the lens, press the lens release
button and turn the lens counterclockwise (7).
Always place the body cap on the camera
when storing it without the lens, and keep
both front and rear lens caps on the lens. To
attach the body cap, fit it into the lens mount
and turn it clockwise one-eighth of a turn (8).
Neckstrap
Attach the neckstrap as shown for the Model
600 (9) and the Model 600 SE (10).
Assembly (Picture 4)
Eyecup
Fit the rubber eyecup over the viewfinder
eyepiece (11).
Lens hood
Screw the collapsible rubber lens hood onto
the lens (12). For best picture-taking results,
a lens hood should always be used. For
storage, you may fold it back over the lens
barrel and put on the lens cap.
Film holder
The removable film holder is attached to the
camera by means of two sliding locks on
either side of the camera body (13). When
attaching the film holder, be sure it is properly
seated and that the film tab slot is on the
opposite side of the camera from the hand
grip (14).
If there is film in the holder, be sure the dark
slide is inserted before removing the holder.
To Next Page
Loading...
Need help?
General
