600 Series Camera User Guide
9
Using the camera
Loading the camera
Use only Polaroid 600 color film.
1. Push the latch forward. The film door will
open.
2. Hold the film pack by its edges only, as
shown (printed side up), and slide it all the
way into the camera.
3. Close the film door.
When you close the film door:
• film cover will eject.
• picture counter will set to 10.
Removing empty film pack from camera
When the picture counter is blank, open the film
door and pull the colored tab to remove the film
pack.
Raising and lowering the electronic
flash unit
1. Grip the sides of the flash unit.
2. Swing the flash unit up to snap it in place.
3. The flash will fully charge, automatically,
in about 3 seconds every time you:
• Load film into the camera when the flash
unit is raised.
• Raise the flash unit when there is film
already in the camera.
• Take a picture.
• Touch the shutter button.
Note: The flash is designed to be used
for every picture – outdoors or
indoors.
When you are not using the
camera, lower the flash unit. It will
protect the lens and lock the red
button.
Latch
To Next Page
Loading...
