17
1.3 Ink scraping position: observe the moving distance of the trolley during ink scraping to
ensure that the blade should scrape the nozzle fully. If the distance is not enough to scrape
the nozzle fully, you can adjust the starting and ending positions of ink scraping in the
factory mode.
1.4 Adjustment of ink pump parameters: the diaphragm pump has large power and strong ink
pumping force. When setting the cleaning, the ink pumping time is controlled at about 1-2
seconds (1 second equals 1000 milliseconds). If the ink pumping time is too long, the ink on
the surface of the nozzle will be sucked back to the ink bag. It is recommended that the ink
pumping time for ordinary cleaning be set to about 800 milliseconds and the cleaning time
be strengthened to 2000 milliseconds. The delay waiting time is 5000 milliseconds by
default, and the indoor water-based machine can be increased to 8000 milliseconds or
more.
1.5 Adjustment of flash parameters: it is recommended to set the frequency of flash after
cleaning and before printing as 1KHZ, the number of times of cleaning flash is 4, the flash
time is 2000-4000ms, and the interval is 300-500ms.
Precautions: The flash frequency shall not exceed 1KHz, otherwise ink break is likely to
occur, and the comprehensive flash time before printing shall not exceed 25 seconds,
otherwise the software will report an error of "exceeding the waiting time".
To Next Page
Loading...
