3
Chapter I Safety Guidance
Before using the POLAROID FIRST series printer, please read the following
instructions and follow the warnings and instructions marked on the printer.
1.1 Important safety guidance
• Be careful not to spill liquid into the printer.
• Do not put any objects on the printer platform, and be careful not to spill liquid into the
printer.
• Connect all equipment to an appropriate grounding socket to avoid switching between the
socket used and the equipment switching between the on and off of high-power systems
such as air conditioners in the same circuit.
• Avoid sockets controlled by wall switches or self-timers
• Keep your computer system away from potential sources of electromagnetic interference,
such as fans.
• Do not use damaged or worn power cord.
• If an additional power cord is used, remember that the total amperage of the equipment
plugged into the additional power cord should not exceed the rated amperage of the
power supply. In addition, remember that the total amperage of all equipment plugged into
the wall should not exceed the rated amperage of the wall socket.
• Do not attempt to repair the printer yourself.
• In case of the following situations, please ask experienced maintenance personnel to
maintain after cutting off the power supply.
▪ If the power cord or plug is damaged
▪ If liquid splashes into the printer
▪ If the printer falls down or the case is damaged
▪ If the printer does not operate normally or there is a significant change in
performance
1.2 Precautions when using the printer
• Do not move the print head by hand, or the printer may be damaged.
• Always use the power switch to turn off the printer. However, when this key is pressed, the
power will be cut off. Do not unplug the printer plug or data cable before the power is cut
off.
• Before handling the printer, ensure that the print head is in its original position and fixed.
To Next Page
Loading...
