4
1.3 Precautions for using ink bottle
• Please keep the ink bottle out of the reach of children. Do not let children drink ink or touch
the ink bottle.
• If the ink sticks to your skin, wash it with soap and water. If the ink splashes into the eyes,
please wash it with water immediately.
• Do not shake the ink bucket, which may cause ink leakage.
• After using the ink bucket for a period of time (generally three months), take it down
immediately for thorough cleaning and air drying. When replacing a new ink bucket, pay
attention to cleaning to ensure printing quality.
1.4 Printer installation requirements
• Site preparation
It is the responsibility of the customer to comply with all installation requirements and to perform them
during machine operation. If this is not done, the machine may not operate properly.
• Work area
The working area refers to the area close to the POLAROID FIRST series machine (hereinafter referred
to as the equipment). It must be emphasized that the user should ensure the safety of the operators
in this area. The working area is 6m long, 4m wide and 3m high.
• Environmental requirements
The equipment shall be kept away from radio frequency sources. The floor shall be easy to clean
without generating dust and static electricity. In order to help operators and customers judge the
accuracy of color, neutral gray decoration and pure white light (fluorescent lamp) should be used as
far as possible. The equipment shall be installed in a clean, dust-free environment where the
temperature and relative humidity are controlled within the following range: altitude: below 1000
meters above sea level; operating temperature: 18-28 ℃; relative humidity: 40% - 60%.
• Load bearing requirements
POLAROID FIRST printer 200KG (140KG net weight without package) color fixing machine
300KG (260KG net weight without package).
The equipment shall be installed at the place of relative plane and the anchor shall be screwed
down for support.
• Space reservation requirements
The front of the equipment refers to the input side of the machine. It is required to reserve 1.0m in
front of the equipment. Keep 1.0m on the back and 1.0m on the left and right sides respectively. In
addition, the space reserved area also includes a height of 3 meters above the ground. In addition,
space should be left in front of and behind the machine for loading and unloading pictures and
consumables.
To Next Page
Loading...
