Mounting the device in a Car
11
Device
Bolt
Angled-support
bracket
Headrest
Car seat
Horizontal-support
Use the supplied mounting kit to install the device on the back of
the vehicle’s headrests.
1. Align the angled-support bracket and bolt to the screw hole on the
back of the device. Turn the bolt clockwise and secure the angled-
support bracket.
2. Lift the headrest off its leg supports. Align the horizontal support
with the headrest leg slots and ensure the horizontal-support rests
securely on the top of the car seat. Reattach the headrest.
3. Grip the device firmly with both hands and slot the angled-support
bracket firmly into the horizontal-support until it clicks. Ensure the
entire unit is secure.
4. Adjust the angle of the device and then secure it by tightening
the bolt on the right.
5. To remove the device from the horizontal-support, firmly squeeze
the release buttons on either side of the angled-support and pull
while supporting the device with the other hand.
To Next Page
Loading...
Need help?
General
