REMOTE CONTROL | 11
MODE
SD CARD
LED
USB
• If a USB or SD card has already been inserted when the unit is switched on, the music from the USB or SD card will
be played automatically.
• When playing a vinyl disk, press and hold the MODE button for 2 seconds to start recording and the LED on the right
side of the turntable will flash. Press the button to stop recording.
• To play the recorded file, put the tonearm back to the armrest. The music will be played automatically from the USB
or SD card. Then press the MODE button again, and the recorded file will be played.
• To delete the recorded music from the USB or SD card, press and hold the button until the music stops playing.
Connect to an External Amplier using the Line Out Port
Use a RCA audio cable to connect to the Line Out port (L/R) at the back of the turntable, and then connect to the your
external amplifier.
Note that the internal speaker and the Line Out port will have output at the same time.
Playing Music from or Record Music to USB/SD card
The panel on the side of the turntable allows you to play music from a USB/SD card and record music directly from the
vinyl.
1. MODE: Press to switch between
Bluetooth
®
/SD/USB.
If there is recorded music in the SD/
USB, pressing the button will switch
to the recorded folder.
2. : Play previous track
3. : Play next track
4. : Press to play or pause. Hold
to delete current music. In REC
mode, press to stop recording.
1 2 3 4
NOTES:
To Next Page
Loading...
General