5. Installation of foot bracket beam: both ends
of the beam are fixed with M6 * 20 hexagonal
socket combination screws
6. Installation of the left and right side plates of
the feeding and the paper dispenser: use M6 *
20 hex socket combination screws to fix the side
plates and thread them into the steel pipe and
the feeding
7. Machine head installation: use M6 * 20
hexagonal socket combination screws to fix the
machine head and the rigid support
8. Installation of waste ink bottle and ink bucket:
fix the ink bucket with M6 * 20 socket head cap
screws. The ink bucket and ink bucket bracket
are fixed with the screws provided on the
accessories
4.2 Precautions before installation of head
1. Check the machine:Check the appearance and accessories of the machine to see if they
are complete. Remove the fixed sheet metal parts of the carriage and see if the carriage
can be pushed from left to right normally without abnormal noise.
2. Software installation: install the printing software on the computer and set the local network
IP, as shown in the following figure:
To Next Page
Loading...
