10
3. Online: connect the power supply to the machine, connect the network cable, open the
machine control software on the computer, and turn on the machine. Observe the reset
action of the machine. The specific reset action of the trolley on the platform is as follows:
Start up and wait for about 10 seconds → the cleaning mechanism descends → the
carriage moves about 15cm to the left → the carriage moves to the right and returns to the
original point → the carriage moves to the left again (rebound distance) → the cleaning
mechanism rises → the software is online.
4. Enter the factory engineer mode: in the box behind Software Advanced and Factory
Settings, enter 222222, press Ctrl+F12, and click OK to enter.
5. Horizontal gear ratio calibration: X motor interface, gear ratio setting, calibration behind
the point. After the automatic calibration of the machine is completed, click the save
option under the file in the upper left corner to save.
To Next Page
Loading...
