EasyManua.ls Logo

Polarstart PS-3155 - Using the Remote Control; Vehicle Presets; Heater & Heated Seat

Default Icon
12 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
User guide P. 3
Using the Remote Control
Your Remote Car Starter is equipped with a 5-button multi-channel remote control. It can operate
two independent vehicles equipped with a Remote Car Starter (see Multi-Car Operation section,
later in this Guide, for second-car transmitter functions).
The functions of the transmitter are as follows:
2
nd
generation transmitters (ASRA-2501 or PLRA-2501):
Picture serves as example only.
N.B.: Pressing the
LOCK and UNLOCK buttons simultaneously will activate the AUX 2 output.
1
st
generation transmitters (ASTR-575):
Vehicle Presets
Heater & Heated Seat
When leaving the vehicle it is recommended to preset the accessory controls in preparation for the
next remote start. Settings for the blower motor (fan), front and rear, as well as heated seats (if
equipped) should not be left on
HIGH. It is recommended to leave the settings on LOW or MEDIUM
instead.
LOCK: Locks the doors and arms
the STARTER KILL.
TRUNK: Opens the TRUNK or
activates the AUX 3 output
STOP: Stops the engine if pressed
for less than 3 seconds or triggers
Panic mode if pressed for more than
3 seconds.
UNLOCK: Unlocks the doors
and disarms the STARTER
KILL. Activates the AUX 1
output if priority door access
is configured.
START: Remote starts the
engine or gets the system
into Cold Weather mode if
p
ressed for 3 seconds.

Related product manuals