6
03. ASSEMBLY INSTRUCTIONS
FITTING THE CARRIER ON THE BICYCLE
EN
Make sure you have followed all the prior instructions. If you have followed them correctly the carrier should look like the
pictures above. When done so, the carrier is ready for use. IT IS MANDATORY TO READ the chapter on Caution (06) and
Instructions for Use (07) about using your carrier before using it.
6
Pass the harness to bicycle frame (C) around the bicycle frame seat tube. Adjust it as shown in the picture, under tension.
Make sure the unused portion of the harness is not in contact with the wheel, because it can lock the rear wheel and cause
an accident. This step is extremely important for the child and cyclist safety.
5
C
C
To Next Page
Loading...
