Need help?Do you have a question about the Polk Audio Momo C500.1 and is the answer not in the manual?
General| Channels | 1 |
|---|---|
| THD at Rated RMS Power | < 0.1% |
| Signal to Noise Ratio | >90dB |
| Input Sensitivity | 200 mV - 6 V |
| Fuse Rating | 40A |
| Phase Shift | 0-180 degrees |
| RMS Power at 2 Ohms | 500W |
| Peak Power Output | 1000 Watts |
| Frequency Response | 20Hz - 250Hz |
| Subsonic Filter | 20 Hz |
| Bass Boost | 0-18dB |
Lists the components included with the amplifier, such as hex wrenches and screws.
Instructions to record the product's serial number for service or theft records.
Features include MDH power supply, convection heat sinks, and 5-way protection circuits.
Covers hideaway cover plates, compact footprints, and gold-plated terminals for installation.
Includes high damping factor, subsonic filter, and interference reduction for better audio.
Notes the availability of a remote subwoofer level control on all models.
Features parallel speaker connections and stereo summed mono inputs for easier setup.
Includes variable bass boost, frequency adjustment, and the Pre-EQ switch.
Adjustable low pass filter with switchable slope for crossover management.
Lists essential tools required for performing the amplifier installation.
Warns about potential damage to speakers from amplifier distortion at high volumes.
Critical safety instruction to disconnect the battery ground before any work.
Specifies compatibility with 12-volt negative-ground systems and warns against others.
Recommends planning system layout and cable routing to avoid noise interference.
Advises using a circuit breaker or fuse near the battery for optimal vehicle protection.
Guides on minimizing ground wire length to prevent noise and hum.
Guidance on choosing a location and mounting the amplifier, with safety warnings.
Includes battery disconnection and circuit protection setup before installation.
Guides on routing power, signal, remote, and speaker wires to prevent noise.
Details connecting ground, power, remote, RCA, and speaker wires securely.
Covers control settings, sensitivity adjustments, and initial low-level testing.
Illustrates wiring methods for flush and stealth installation configurations.
Details the jack for connecting the optional remote bass gain module.
Explains setting the low-pass filter frequency and crossover slope.
Covers bass boost frequency, amount, and the Pre-EQ switch.
Guides on selecting input type and setting the amplifier gain.
Diagram for connecting one 4-ohm SVC subwoofer to the amplifier.
Diagram for connecting two 4-ohm SVC subwoofers in parallel.
Wiring for three 4-ohm DVC subwoofers, resulting in 2.67Ω impedance.
Wiring for three 8-ohm SVC subwoofers, requiring 8Ω or higher for parallel setup.
Diagram for connecting four 4-ohm SVC subwoofers in parallel, total impedance 4Ω.
Critical steps for safe power connection, including battery disconnection and wire gauge.
Details proper ground connection and remote turn-on wiring procedures.
Advises using grommets to protect power cables passing through vehicle barriers.
Crucial warning about dangers of prolonged exposure to high sound levels.
Information on obtaining help for installation difficulties or service needs.
Explains the optional Remote Bass Gain Module connection and installation.
Details RMS power output at different impedances and the frequency response range.
Lists signal-to-noise, input sensitivity, and impedance ratings.
Covers low-pass filter, subsonic filter, and bass boost parameters.
Provides the physical dimensions of the amplifier in inches and centimeters.
Outlines warranty coverage, period, and exclusions for defects and damage.
Instructions for product registration and returning defective products for service.
To Next Page
