10
6. Start moving the device in slow motions over the
treatment area (FIG.7). You will feel pleasant warming.
IMPORTANT: be sure to keep the device constantly
moving on your skin. Do not leave the device on one
place without movement, as skin overheating may occur.
7. Treat each area for 4 minutes.
POST TREATMENT
1. Turn the device OFF by pressing the power button
for two seconds.
2.
Gently remove the TriPollar Preparation Balm
from the skin.
3.
Clean the TriPollar Stop Eye device with a soft,
damp cloth or paper towel and cover it with its
protective cover. Do not submerge the TriPollar
Stop Eye under water!
IMPORTANT:
It is recommended to perform a
patch test 24 hours prior to initial use. Apply a
small amount of TriPollar Preparation Balm on the
inner arm and treat the area with TriPollar Stop Eye
device. Ensure that the skin does not have a negative
reaction to the gel or treatment.
INDICATIONS OF SUCCESSFUL TREATMENT
As a natural result of the treatment, the skin may
show some redness (erythema) and minor skin
swelling (edema) in the treatment area. Both should
disappear after a short time.
To Next Page
Loading...
