9
COURSE OF TREATMENT
1. Treatment duration is approximately 4 minutes per
area.
2. For optimal results, use your TriPollar Stop Eye device
2-3 times a week for a period of 6-8 weeks.
3. Make sure you have at least one day interval between
treatments.
4. In order to maintain long term results after you have
finished the full course of treatments, it is recommended
that you use your TriPollar Stop Eye device 2-4 times
a month or as needed.
TREATMENT PROCEDURE
1. Charge the device so that its battery is fully charged
and its LED indicator is steady blue.
2. Cleanse and dry the treatment area.
3. TriPollar Preparation Balm must be used throughout
treatment. Spread an even layer over the entire
treatment area. In case you feel that the balm has
been absorbed during the treatment, spread an
additional layer of TriPollar Preparation Balm.
4. Remove the protective cover from the device. Turn
TriPollar Stop Eye ON by short pressing the Power
Button (FIG.6). Make sure the green indicator LED
appears.
FIG.6
5. Place the device on your skin ensuring that all 4
electrodes are touching the skin. For best results, all
four electrodes must be in full contact with the skin
during treatment.
FIG.7
TREATMENT PROCEDURE
To Next Page
