Polygroup ILLUMINATIONS Series User Manual

Should you encounter any problems, contact Customer Service at (888) 919-0070 from 8 AM to 5 PM Mon. thru Fri.
EST. Extended operating days and hours during peak season requirements.
OWNER′S MANUAL
3
SETUP INSTRUCTIONS
1. Turn the Ground Stake Lock Screw 4 in anti-clockwise to loosen
the ground stake holder on Laser Show 1 by hand. Locate the
ground stake holder to vertical, and screw thread point to the down
side.
2. Put the Ground Stake 3 onto the end of ground stake holder on
the Laser Show 1, and then turn the Ground Stake 3 in
anti-clockwise to tighten the Ground Stake 3 on the Laser Show
1 by hand.
PARTS LIST
Qty. x1 x1
x1
2
Power Supply
3
Ground Stake
4
Ground Stake Lock Screw
1
Laser Show Description
Parts
x1
1
4
1
3
Laser Classification: FDA Class 3a
Laser Wavelength: Red 663nm, Green 519nm
Total Wattage: 10W
Adapter Power Input: 120VAC, 60Hz, 0.22A
1. Laser Show will appear brightest in the dark and may look dimmer if there are competing sources of light, like street lights and porch lights.
2. Laser Show is intended to operate in temperature from -22°F to 100°F (-30°C to 40°C). At or below freezing temperature, it may take few minutes to warm up and
reach its full projection power when first connecting with the electrical power.
Adapter Power Output: 9V, 1.2A
Operation: Indoor/Outdoor
Operating Temperature: -22°F to 104°F (-30°C to 40°C)
PRODUCT DESCRIPTION

Polygroup ILLUMINATIONS Series Specifications

General

Brand	Polygroup
Model	ILLUMINATIONS Series
Category	Lighting Equipment
Language	English