10
• IF YOUR POOL INCLUDES A FILTRATION SYSTEM, INSTALL THE ENTIRE SYSTEM BEFORE FILLING YOUR POOL TO AVOID WATER LOSS.
• FOLLOW THE OWNER'S MANUAL OF YOUR SYSTEM TO INSTALL THE POOL WALL FITTINGS, HOSES AND CLAMPS CORRECTLY BEFORE FILLING
YOUR POOL.
14. Make sure the liner drain fitting is plugged securely and the cap is in place. Then start filling the pool with water until about one inch (2.54cm) of water is on the bottom.
AFTER ABOUT 1 INCH OF WATER IS ON THE BOTTOM, STOP FILLING AND COMPLETELY SMOOTH OUT ALL THE WRINKLES OF THE POOL FLOOR,
WORKING OUTWARDS FROM THE CENTER. MAKE SURE THE POOL FLOOR IS COMPLETELY FLAT SO THAT THE POOL FILLS EVENLY.
IMPORTANT: IF MORE THAN 1-2 INCHES OF WATER COLLECTS ON ANY ONE SIDE BEFORE THE POOL STARTS FILLING IN THE CENTER, THE POOL IS NOT
LEVEL ENOUGH, AND MUST BE CORRECTED.
ADDITIONAL NOTE: THE WEIGHT OF THE WATER WILL PREVENT ADJUSTMENT AFTER THIS POINT.
NOT FOLLOWING THE STEP ABOVE WILL MAKE THE POOL FILL UNEVENLY AND THE POOL MAY LEAN TO ONE SIDE AND COLLAPSE. THE WATER IN YOUR
POOL SHOULD FILL EVENLY. IF YOUR POOL IS LEANING AT ALL; THE GROUND MAY NOT BE LEVEL AND YOU WILL NEED TO START OVER.
• FAILURE TO FOLLOW THE INSTRUCTIONS ABOVE WILL CAUSE POOL TO COLLAPSE AND WILL VOID THE WARRANTY!
15. When the water is approximately half filled, the top frame will tend to bend down at the middle as shown below.
THIS IS ABSOLUTELY NORMAL.
Continue to fill with water up to the fill line printed on the inside of the liner wall, the frame will restore to its normal shape.
IMPORTANT: FOR POOLS THAT INCLUDE A COMPLETE FILTRATION SYSTEM
To Next Page
Loading...
Need help?
General
