11
Prime the Nebulizer
Once the sponge wick is fully saturated with
solvent it will continue to conduct the liquid
solvent to the nebulizer by capillary action.
Initially, however, and also in the event of the
Polysher
TM
not being used for an extended
period of time, the top portion of the sponge
will be dry and the nebulizer will not operate.
It is necessary to rst “prime” the sponge by
dribbling 5-10 drops of alcohol directly onto
the nebulizer itself using the priming pipette.
The solvent will ow through the nebulizer’s
micromachined pores and into the sponge.
Install the Reservoir Cover
Place the “grate” cover over the reservoir.
Install the Platform
Set the platform on the lift tray in the center
of the lid.
6
7
8
To Next Page
Loading...