Need help?Do you have a question about the Polymaker Polysher and is the answer not in the manual?
General| Technology | Vapor smoothing |
|---|---|
| Power Supply | 12V DC |
| Build Volume | Not applicable |
| Layer Resolution | Not applicable |
| Nozzle Diameter | Not applicable |
| Filament Diameter | Not applicable |
| Print Speed | Not applicable |
| Print Bed | Not applicable |
| Compatible Materials | PolySmooth PVB |
| Connectivity | Not applicable |
Connect the power supply to the power port on the lower back of the Polysher.
Connect the power supply to mains power and press the On/Off button.
Press the Open/Close button to raise the platform to its fully-open position.
Firmly press the nebulizer down into its socket, ensuring a satisfactory connection.
Fill the reservoir with alcohol (70%+) to approximately 80-90% capacity using the suction pipette.
Dribble 5-10 drops of alcohol onto the nebulizer membrane to saturate the sponge.
Place the 'grate' style cover over the reservoir for operation.
Set the platform on the lift tray in the center of the lid.
Place your PolySmooth print in the center of the platform for even polishing.
Press the OPEN/CLOSE button to lower and seal the part into the chamber.
Rotate control knob clockwise to set time; mist will fill chamber as part rotates.
Turn chamber lighting on/off and adjust mist lighting color using buttons and knob.
Cycle completes automatically or can be stopped; clearing cycle removes mist.
Open chamber after clearing cycle, remove part, and let it dry for about an hour.
Exchange grate cover with solid cover to prevent evaporation when not in use.
Troubleshoot Nebulizer Warning Light by checking unit seating and reservoir level.
Address low mist volume by checking reservoir level and refilling if necessary.
Use the provided pipette to remove alcohol from the reservoir safely.
Instructions for fully removing and reattaching the Polysher casing.
To Next Page