PolyScience Standard Controller Models User Manual

Table of Contents
Section 1 – General Information
1.1 Warranty
1.2 Unpacking
Section 2 – Circulating Bath
2.1 Contents
2.2 General Description
2.3 Circulator Pump
2.4 Pump Inlet and Outlet Connections
2.5 Closed Loop Circulation
2.6 Filling the Reservoir
2.7 Reservoir Purge
Section 3 – Immersion Circulator
3.1 Contents
3.2 General Description
3.3 Circulator Pump
3.4 Set-Up
3.5 Connections to External Apparatus
3.6 Attainable Temperatures
Section 4 – Standard Controller Information
4.1 Front and Rear Panels
4.2 Heater/Pump Assembly
4.3 Specifications
Section 5 – Operation
5.1 Circulator Location
5.2 Reservoir Liquid Level
5.3 Power
5.4 Setting the Safety Set Set Point
5.5 Selecting Temperature Units
5.6 Setting the Software High Limit
5.7 Setting the Set point Temperature
5.8 User-Defined Preset Temperatures
5.9 Local Lockout Feature
5.10 Stick-on Strips for Preset Buttons
5.11 Auto-Refrigeration Operation
5.12 Controller Display Messages
Section 6 – Calibration and Maintenance
6.1. Calibration
6.2 Heater
6.3 Pump Motor
6.4 Cleaning
6.5 Maintaining Clear Bath Water
6.6 Condenser, Air Vents, and Reusable Filter (Refrigerating/Heating Circulators only)
Section 7 – Troubleshooting
7.1 Unit Will Not Operate (No Heat, Cooling, or Pumping)
7.2 No Pumping
7.3 Slow or Insufficient Pumping
7.4 No Heating
7.5 Insufficient Heating
7.6 No Cooling or Insufficient Cooling
7.7 Triac Failure
Section 8 – Reservoir Fluids
Section 9 – Service and Technical Support
Section 10 – Replacement Parts

PolyScience Standard Controller Models Specifications

General

Brand	PolyScience
Model	Standard Controller Models
Category	Temperature Controller
Language	English