EasyManuals Logo

Poniie PN2000 User Manual

Poniie PN2000
9 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #5 background imageLoading...
Page #5 background image
Under the “CURdisplay interface, pressSETfor 2 seconds to enter
backlight setting interface. It will display “LEd” after entering the interface,
and the ON or OFFis flickering (as shown in Figure 1). At this time, you can
select to turn ON or OFFby pressing
or button momentarily, and
after selection, press the OK” to exit setting. “OFF” means when the device
has no button operation in 10 seconds, the backlight will automatically off
(fault factory setting); “ON” means the backlight will always on.
3. Measure and operation
1E AMeasuring mode
Under measuring mode one can freely check working Current, Voltage, active
power Watts, Frequency, Electricity Consumption(EC), Cumulative Time(CT)
and Power Factor(PF) by pressing
”: WATTCURVOLTFREQ
CTECPF. Press “the check sequence shall be reversed.
A
2E AElectricity Consumption & Cumulative Time
Respectively switch to cumulative Electricity Consumption(EC) monitoring
interface (as shown in Figure 2) and cumulative Consumption Time(CT)
interface (as shown in Figure 3) by pressing
or ”, and the measuring
display ranges shall be 0.00-99,999kWh and 0-99,999 minutes respectively.
The measured electricity consumption value will be automatically stored, and
will not be lost even under long time outage, which is great for circuits that
loose power.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Poniie PN2000 and is the answer not in the manual?

Poniie PN2000 Specifications

General IconGeneral
BrandPoniie
ModelPN2000
CategoryMeasuring Instruments
LanguageEnglish

Related product manuals