6-37
6. Replace the bulb by pulling the old one out and
gently pushing the new one into the lamp socket.
7. Line up the tabs on the socket with the gaps in the
socket holes and screw the bulb socket back into the
lamp housing until a click is heard (the tab popping
back out).
8. To reinstall the lamp assembly, align the tapered pin
on the bottom of the lamp with the plastic socket on
the fender bracket. Push down until the pin snaps
into the socket.
9. Reinstall the two screws that were removed in Step 2.
Stop Lamps and Taillamps
1. Open the liftgate and the tailgate.
2. Using a 7 mm
socket, remove the
two screws from the
taillamp housing.
3. Gently rotate the lamp outboard, then pull the
assembly firmly rearward.
To Next Page
Loading...
