Pool Frog 6100 - Step 2: Putting the System to Work

7
Replacing a POOL FROG® Mineral Reservoir
(POOL FROG® Mineral Reservoirs MUST be Replaced Every Season)
1.
Check the top of the box and back label of product to make
sure you have the correct POOL FROG® Mineral Reservoir to fit
your POOL FROG® Cycler.
THE POOL FROG® MINERAL RESERVOIR MUST BE
REPLACED EVERY 6 MONTHS OR AFTER ONE POOL
SEASON WHICHEVER IS SHORTER.
IMPORTANT: Remove and read the
information card.
Please note: Complete instructions
for inserting a POOL FROG® Mineral
Reservoir, FROG BAM® and POOL FROG®
Bac Pac are included inside the POOL
FROG® Mineral Reservoir.
USE ONLY the factory recommended
replacement POOL FROG® Mineral Reservoir,
FROG BAM® and POOL FROG® Bac Pac. DO
NOT USE bulk chemical tablets in the POOL
FROG® Cycler or put anything inside the POOL
FROG® Cycler, other than the appropriate POOL
FROG® product as directed in the product
instructions. Use of any other product could
result in damage to pool equipment or surface,
unsafe pool conditions, fire or explosion.
Warranty will be void if the correct POOL
FROG® Mineral Reservoir, FROG BAM® and
POOL FROG® Bac Pac are not used.
2.
3.
Turn off pump and turn dial
to Setting 0. This reduces
the flow of water into the
unit when the cap is open.
4.
Open cap. Stand back
to avoid inhaling chlorine
fumes from the POOL
FROG® Bac Pac.
5.
Find slot on side of
POOL FROG® Mineral
Reservoir and line
up with fin inside the
POOL FROG® Cycler.
Lower POOL FROG®
Mineral Reservoir
into POOL FROG®
Cycler until secure.
6.
A bove Ground Series 6100 (Order #01-12-6112)
Now Fits the Following Cyclers:
POOL FROG Series 5100, 5200 or 6100
Prevail Series 5770 or 5771
®