No Diving or Jumping. Observe all Safety Rules.
3-5
e. A vacuum cleaner can later be used
to remove the air from between the
liner and the wall. This technique
enables you to remove folds in the
liner. However the following precau-
tions should be taken:
Do not use an industrial vacuum
cleaner which could be too powerful.
Tape the end of the vacuum hose
before inserting it into the wall so as
not to damage the liner.
Insert the nozzle until it is about
4” (10cm) above the cove (insert
through the water return outlet or the
skimmer depending on the diameter
of your hose). Make sure you will be
able to remove the hose later on.
Tape the hose to the wall.
f. Close the skimmer opening with
cardboard and adhesive tape so that
the suction of air works better..
14
15
To Next Page
Loading...