No Diving or Jumping. Observe all Safety Rules.
3-4
Remember:
The bolt heads must be
toward the inside of the
pool. Cover the bolt heads
with duct tape.
4. Make a Cove
a. If you are using sand, bank the sand
against the wall to form a cove of 3”
to 6” (7.5cm to 15cm) high and 8” to
12” (20cm to 30cm) wide at ground
level. This will prevent the liner from
creeping under the wall, and it will
also protect the liner from any metal
edges of the pool framework. THIS
STEP IS NOT OPTIONAL, IT
MUST BE DONE. .
b. Water the sand to compact it and use
a trowel to spread it evenly.
c. Since earth containing chemicals can
cause discoloration or corrosion, it is
suggested that you place polyethyl-
ene plastic sheeting under the cove
around the perimeter of the wall, so
no earth comes in contact with the
metal. Since the presence of such
chemicals is beyond the control of
the manufacturer, such damage is not
covered under warranty.
d. If you are using styrofoam cove
pieces instead of sand, insert them in
the bottom rail and refer to the instal-
lation instructions that are provided
with them.
11
12
13
Remember:
The cove is an important
part of the pool structure.
Take your time to make a
complete, full-size cove.
To Next Page
Loading...