To Next Page
R
Richard YoungJul 31, 2025
What to do if PoolEye Lighting Equipment alarm is not sounding?
- GGregory AlexanderJul 31, 2025
If the PoolEye Lighting Equipment alarm isn't sounding, there are several potential causes: * **Low battery:** Install new batteries. * **Alarm not activated:** Ensure the main switch is turned to the ON position. * **Sensitivity:** If the sensitivity is set on L (Low), ensure it is set to H (High). If the sensitivity is set on H (High), adjust it to L (Low). * **Water level:** If the water level is too high, lower it closer to the minimum requirement. If the water level is low, raise it to the minimum requirement. * **Sensor shield:** Remove the sensor shield from the sensor cage if it's blocking the wave.
General