Poolguard PGRM - 2 - REMOTE RECEIVER

REMOTE RECEIVER
When the unit at the pool alarms, the remote receiver will sound.
Maximum Range for the remote is 200 feet from the poolside unit.
Avoid placing remote in basements or close to metal walls. Be sure that
the red light on the remote is on. Remember the poolside unit must be
beeping (alarming) for the remote to work.
If your remote receiver is not getting a clear signal or no signal from the
poolside unit, try the following: Before plugging in the power supply, be
sure to stretch out the cord; do not leave it tied in a bow as packaged.
Your Remote Receiver is similar to a small portable radio. If your remote
is not sounding when the poolside unit is sounding-move the remote
to different locations and stand back for a few seconds for the remote
to pick up the signal. You may only have to move your remote a little
to the left or right to bring in the signal-in some cases you might have
to move the remote to a different location or another room. If you cannot
get a signal on your remote receiver CALL CUSTOMER SERVICE AT
1-800-242-7163