CERTIFICATION
NSF
International
Certifies
that
the
POOLGUARD
Pool
Alarm
Model
PGRM-2
conforms
to
the
requirements
of ASTM F2208 -
Standard
Safety
Specification for Residential Pool alarms.
1. Certified to ASTM
F2208-2008
for performance.
2. Certified to NSF/ANSI
Standard
50 for material safety. Certified
pool
and
spa
end
use
temperatures.
POOLGUARD Pool Alarm Model PGRM-2
will
meet or exceed
all
parts
of
the
Tennessee
Pool
Alarm
requirements
of the Katie Beth Law.
INSPECTION
POOLGUARD is
packaged
in a shipping carton that minimizes the chance
of
damage
due
to handling. Check for
damage
and confirm that the con
tents
of
the
carton
include
the
following items:
•POOLGUARD
Unit
•
Handle
•
Red
Reset/Sleep
Key
•
Remote
Receiver
and
Power
Supply
• Operating Instructions Manual
If
an
item is
missing,
contact
either
the
place of
purchase
or
PBM
Industries,
Inc. for
replacement.
CARE
AND
HANDLING
POOLGUARD
is
constructed
from
sturdy
plastic to withstand the
adverse
moisture
environment
of a swimming pool.
Care
needs
to be taken when handling to ensure
against being dropped, kicked, etc.
ALWAYS
REMOVE
THE
POOL
UNIT
FROM
THE
POOL
WHEN
THE
POOL
IS
BEING
USED.
STORE
THE
ALARM IN THE
UPRIGHT POSITION
(See
Figure
1) AWAY FROM POOL
ACTIVITY.
If
the
pool
unit accidentally falls into your pool, remove it immediatelyand drain the water
from it.
Take
the
pool unit
apart
as
indicated
in
the Battery Installation/Replacement
section
and
remove
the
battery.
Remove
all the water from the inside of the
unit,
the
battery and
the
circuit board
area
with a paper
towel
or
cloth.
Completely test
the
alarm
before
each
use
as
described
in
the
manual
to
ensure
proper
operation.
CAUTION:
KEEP
THE
RED
RESET/SLEEP
KEY
OUT
OF
THE
REACH
OF
CHILDREN.
INTERNAL
MAGNET
MAY
BE
HARMFUL
IF
SWALLOWED!
To Next Page
Loading...
