EasyManua.ls Logo

Poolguard PGRM - 2 - ATTACHING HANDLE; OPERATING YOUR ALARM; RESET;SLEEP MODE; SILENT INSTALLATION AND REMOVAL FEATURE

Poolguard PGRM - 2
16 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
ATTACHING
HANDLE
The
two handle
screws
are
located in the top of the alarm, remove them
and
attach
the
handle,
(See
Figure 1).
OPERATING
YOUR
ALARM
RESET/SLEEP
MODE
(SEE
FIGURE 1)
RESET:
When
the
pool
unit
is
installed
in
the
pool
and
the
horn
is
sounding;
place
the red reset/sleep key on the reset/sleep decal to reset and silence the alarm. The
pool
unit is now monitoring your pool for an intrusion.
SLEEP
MODE:
When
the
pool unit is removed
from
the pool and the horn is
sounding; place the red reset/sleep key on the reset/sleep decal for 3 to 4 seconds
to activate sleep mode and silence the alarm.
To
store the
alarm,
place the
alarm
in
the upright
position
(See
Figure
1).
The pool unit
will
automatically
wake
up
when
it
is
re-installed
into
your
pool!
SILENT
INSTALLATION
AND
REMOVAL
FEATURE
The
Poolguard system
will
sound an alarm
(Horn
will
sound)when
you
install
or remove the pool unit from your
pool.
If
you
would
like
the Poolguard system
not to sound an alarm
(Horn
will
notsound)
when
you
install
or
remove
the
pool
unit
from
your
pool, follow
the
directions below.
1.
SILENT
INSTALLATION
(HORN
WILL
NOT SOUND)
Hold
the red reset/sleep key on the reset/sleep decal
for
1second
until
you
hear
the
pool units horn beep. Remove the red reset/sleep
key,
you
now
have 10
seconds
to install
the
pool unit into your pool without the
horn
sounding. AFTER
10
SECONDS,
THE
POOL
UNITS
HORN
WILL
BEEP
INDICATING
THAT
POOLGUARD
IS
NOW
MONITORING
YOUR
POOL FOR
AN
INTRUSION.
2. SILENT
REMOVAL
(HORN
WILL
NOT SOUND)
Before removing the pool
unit
from
your
pool.
Place the
red
reset/sleep
key
on
the
reset/sleep
decal for 1
second
until
you hear the
pool
units horn beep.
Remove
the
red
reset/sleep
key,
you now have 5 seconds to remove the
pool
unit
from
your
pool
without
the
horn
sounding.
AFTER
5
SECONDS
THE POOL
UNITS
HORN
WILL
BEEP.
IMPORTANT:
IF
THE
POOL
UNIT
WAS
REMOVED
FROM
YOUR
POOL,
THE
POOL
UNIT
WILL
GO
TO
SLEEP.
BE
SURE
TO
STORE
YOUR
ALARM
IN
THE UPRIGHT POSITION (SEE FIGURE 1).
IF
THE
POOL
UNIT
WAS
NOT
REMOVED
FROM
YOUR
POOL,
IT
WILL
CONTINUE
TO
MONITOR
YOUR
POOL
FOR
AN
INTRUSION.
(Cont.
on
next
page)
^

Related product manuals