Poolguard PGRM - 2 - BATTERY INSTALLATION; REPLACEMENT; ON;OFF INDICATOR - GREEN LED; LOW BATTERY FUNCTION

SILENT INSTALLATION AND REMOVAL FEATURE (Cont.)
3. POOLGUARD has designed this feature for "ONLY" those who
have the responsibility of removing the alarm from the pool!
BATTERY INSTALLATION /REPLACEMENT
(Battery not included)
POOLGUARD is powered by a standard 9 volt alkaline battery, POOLGUARD
recommends Energizer No. 522. To install or replace the battery:
• Remove the screw from the bottom of the unit, (See Figure 1).
• Carefully slide out electronics assembly; do not pull or jerk on internal
hook up cable. (If necessary, gently shake unit to remove assembly.)
• Remove old battery and check for leakage or corrosion. (Remove any
leakage or corrosion if present before installing new battery.)
IMPORTANT: WHEN A9 VOLT BATTERY IS FIRST INSTALLED IN THE POOL
UNIT THE HORN WILL SOUND. TO SILENCE THE ALARM HOLD THE RED
RESET/SLEEP KEY ON THE RESET/SLEEP DECAL FOR 3 TO 4 SECONDS
TO ACTIVATE SLEEP MODE AND SILENCE THE ALARM. THE POOL UNIT
WILL AUTOMATICALLY WAKE UP WHEN IT IS INSTALLED INTO THE POOL
. Install a new battery by attaching the battery snap (BE SURE THE CONNECTION
IS TIGHT). Slide battery into battery holder.
. Slide the electronic assembly into the pool unit; DO NOT PUT IN UPSIDE DOWN
nR PIMHH THE INTERNA! HOOK UP CABLE.
• Replace the screw, hand tighten until screw is all the way in and flush
against the pool unit.
To prevent possible damage, battery should be removed whenever storing
the alarm, for an extended period of time.
ON/OFF INDICATOR - GREEN LED
When POOLGUARD is installed and monitoring your pool for an intrusion, the green LED will flash
once approximately every 10 seconds to indicate that the alarm is ON and OPERATING. When
POOLGUARD is installed in your pool and the alarm is sounding, the green LED will flash
approximately 2 times per second.
When POOLGUARD is removed from your pool the GREEN LED will not flash indicating that
the alarm is OFF and NON-OPERATIONAL
LOW BATTERY FUNCTION
The POOL UNIT AND THE REMOTE RECEIVER will beep once
approximately every 10 seconds to alert you that the battery is low
in the pool unit and needs to be replaced.