CARE AND HANDLING
POOLGUARD “Safety Buoy” is constructed to withstand the
adverse moisture environment of a swimming pool. Care
needs to be taken when handling your alarm and be sure to
remove the alarm when the pool is being used and place it
on the Red “Safety Buoy” Alarm Storage Stand. Remember
to always remove the alarm from the pool before swimming.
CAUTION: KEEP THE RED RESET/SLEEP KEY OUT OF
THE REACH OF CHILDREN. INTERNAL MAGNET MAY
BE HARMFUL IF SWALLOWED!
OPERATING YOUR ALARM
RESET/ SLEEP MODE (See Figure 1)
RESET: When the pool unit is installed in the pool and the
horn is sounding; place the red reset/sleep key on the
reset/sleep decal to silence the alarm. The alarm is now
monitoring your pool for intrusion.
SLEEP MODE: When the pool unit is removed from the pool
and the horn is sounding; place the red reset/sleep key on
the reset/sleep decal for 3-4 seconds to activate sleep mode
and silence the alarm, place the alarm on its storage stand.
Note: The horn will sound if the Sensor Assembly is
moved. The pool unit will automatically wake up when it
is installed in the pool.
SILENT INSTALLATION AND REMOVAL FEATURE:
The POOLGUARD system will sound an alarm (Horn will
sound) when you install or remove the pool unit from your
pool. If you would like the POOLGUARD system not to
sound (Horn will not sound) when you install or remove the
pool unit from your pool. Follow these directions.
18 3
continued page 4
NOTES
PG Buoy Manual 5.5x8.5 031116.indd 3 3/22/16 2:02 PM
To Next Page
Loading...