poolstar 57001A - First Start-Up

13
For the rst start-up, it is important to clean the sand present in the lter.
This should be repeated from time to time when you feel that the water in your pool is
no longer su󰀩ciently clean or depending on the pressure on the gauge.
Step 1
Make sure the 6-way valve is in the closed position (5).
Unscrew the drain plug (D) and insert a 32/38 connector (not supplied).
Insert a pipe to this tting and position the other end in a sewer.
Position the 6-way valve in the Backwash position (4) and start the ltration unit.
Once the drain water is no longer cloudy, stop the ltration unit.
Step 2
Position the 6-way valve on the rinsing position (2) then restart the ltration unit until
the water at the drain outlet is clear.
Step 3
Stop the ltration unit, reposition the 6-way valve to the closed position (5) then uns-
crew the drain connection pipe and reposition the drain plug (D) and tighten it, checking
that the seal is positioned and in good condition.
Step 4
Put the 6-way valve in the Filtration position (1) and reconnect the ltration unit.
You can now enjoy your pool with a cleaned lter.
First start-up