poolstar 57001A - Different Operating Modes; Circulation Mode

16
Di󰀨erent operating modes
1 Filtration
2 Rincage
3 Circulation
Filtration (1):
This function is used to lter the pool
water. The water is pumped from the
pool and then passes through the sand
lter to be returned to the pool.
Rinse Mode (2):
This function is used for initial start-up,
cleaning and leveling of the sand layer
after backwashing. The water is suc-
ked through the layer of sand and then
returned through the waste outlet (D).
Circulation Mode (3):
This function circulates the pool water
without passing through the sand lter.
You can use this function if the lter
is broken or if the sand is no longer
operational.
Suction
Discharge waste
waste
waste
Suction
Discharge
Suction
Discharge