What to do if poolstar POOLEX Sel-in 20 Swimming Pool Filter shows Error E5 (salt concentration is too low)?
If your poolstar Swimming Pool Filter displays error E5, test the salt concentration of the water. If it's too low, add salt until the concentration reaches 3 g/l. Ensure the chlorinator is switched off until the salt has fully dissolved.
What to do if poolstar Swimming Pool Filter shows Error E3 - Water flow not detected?
If the poolstar Swimming Pool Filter shows error E3, you should: * Check that the filtration time is sufficiently long. * Make sure the bypass is providing enough water to the cell. * Check that the filter is not clogged. * Ensure the flow rate is sufficient. * Clean the cell if debris/scale deposits obstruct the flow sensor.
What to do if poolstar POOLEX Sel-in 20 Swimming Pool Filter shows Error E2 - Water temperature is outside of normal operating range?
If your poolstar Swimming Pool Filter displays error E2, check the water temperature. If it's below 10°C, consider winterizing your device. If it's above 45°C, switch off the chlorinator and wait for the temperature to drop to the normal operating range.
What to do if poolstar POOLEX Sel-in 20 shows Error EA - Cell error?
If your poolstar Swimming Pool Filter shows error EA, first test the salt concentration and correct it if necessary. If the error persists, contact customer support for a replacement cell.
What to do if poolstar Swimming Pool Filter shows Error EC - Electronics error?
If your poolstar Swimming Pool Filter is showing error EC, unplug the transformer, wait one minute, then plug it back in. If the error continues, contact customer support for replacement circuit boards.
What to do if the Poolstar Swimming Pool Filter displays water flow not detected (E3)?
If your Poolstar Swimming Pool Filter shows a 'Water flow not detected' error (E3), verify the following: - Ensure the filtration time is long enough for the entire treatment. - Confirm the bypass provides enough water to the cell and valves are correctly set. - Check if the filter is clogged; clean it if needed. - Make sure the water flow rate is sufficient. - Inspect the cell for debris or scale deposits that may obstruct the flow sensor; clean if necessary. If the error persists after these steps, contact customer service for a replacement flow sensor.
What to do if poolstar POOLEX Sel-in 20 Swimming Pool Filter indicates salt concentration is too low (E5)?
If your Poolstar Swimming Pool Filter indicates that the salt concentration is too low (E5), test the salt concentration of the water. If necessary, add salt until reaching 3 g/I, and ensure the chlorinator is switched off until the salt has fully dissolved.
What to do if Poolstar Swimming Pool Filter displays water temperature is outside of normal operating range (E2)?
If the Poolstar Swimming Pool Filter displays that the water temperature is outside of the normal operating range (E2), winterize your device if the water temperature is below 10°C. If the water temperature is above 45°C, switch off the chlorinator and wait for the temperature to drop to the normal operating range.
What to do if poolstar POOLEX Sel-in 20 shows electronics error (EC)?
If your Poolstar Swimming Pool Filter is showing an electronics error (EC), unplug the transformer, wait one minute, and then plug it back in. If the error persists, contact customer support for replacement circuit boards.
General| Brand | poolstar |
|---|---|
| Model | POOLEX Sel-in 20 |
| Category | Swimming Pool Filter |
| Language | English |
To Next Page
