A
B
D
F
E
C
6
Remove the lawnmower from carton.
1. Carefully read and understand all instructions
before attempting to assemble mower.
2. Assemble the lower handle on to the deck and
insert the coach bolt (F) from the inside out into the
square hole and handle. Attach the plastic knob
and tighten (E) see diagram.
Note: There are 2 positions in which you can secure
the lower handle, choose the one relevant for the
user’s comfort.
Cables that are bent, kinked or damaged in any
way during installation could cause an unsafe
operating condition. An authorised Pope dealer
should be contacted if this occurs. Do not
attempt to repair cable.
7. Lift rear grass flap of the lawnmower and place the
grass catcher frame side hook on the hinge shaft of
the rear grass flap. The grass catcher is secured to
the lawnmower housing when the rear grass flap is
lowered on to the grass catcher. Spring tension
from the rear grass flap will prevent removal of
grass catcher during operation.
8. Reconnect the spark plug cap (C) see diagram.
Warning
F
Assembly / Operating Tips
Assembly
3. Affix the upper handle using coach bolt. Attach the
plastic knob and tighten.
4. Disconnect the spark plug cap (C) see diagram.
5. Engage the safety stop lever (A) by pushing
towards the handlebar. Extend the starter cord to
retainer (B) in upper handle.
6. Attach a cable tie around the throttle and blade
brake cables (D).
To Next Page
