OPERATION
WARNING! Do not allow familiarity with this product to make you careless.
Remember that a careless fraction of a second is sufficient to inflict serious
injury.
WARNING! To avoid any accidental personal injuries do not touch the
cable drum while it is rotating.
● Always remove battery pack from the tool when you are assembling parts, making adjustments, cleaning or when not in use. Removing
battery pack will prevent accidental starting that could cause serious personal injury.
● Always wear eye protection with side shields marked to comply with ANSI Z87.1. Failure to do so could result in objects being thrown
into your eyes and other possible serious injuries.
● Do not use any attachment or accessories not recommended by the manufacturer of this product. The use of attachment or accessories
not recommended can result in serious personal injury.
The drain auger can be used to clear obstructions from a variety of drains including sink, bathtub, and toilet drains, and can be used to
clear drain pipes with minimum diameter of 0.75 inch and maximum diameter of 2 inch.
NOTE: When removing an obstruction from a sink or a
bathtub, it maybe necessary to remove the stopper or
overflow cover to gain access to the drainpipe. Toilet
drains can be accessed directly through the base of the
bowl.
Hold the drain auger within four inches of the drains or
overflow, and manually feed the cable into the drain
pipe.
NOTE: Advance the cable slowly at first. Advancing it
too rapidly can result in twisting or binding.
After feeding about six inches of cable into the drain, you
may begin advancing the cable using the switch trigger
and operation switch or continue advancing it manually.
The cable should advance freely through the drain pipe
until it contacts the obstruction or is caught in a P-trap.
If the cable is caught in a P-trap, additional force or
increased trigger pressure should be enough to advance
it past the bend in the pipe.
If the cable has contacted an obstruction, there are two
ways to remove it.
1. Advance the cable by squeezing the switch trigger while holding the operation switch on the front handle, hold the switch trigger
for several seconds allowing to tip of the cable to bore into the obstruction. If the cable stops the rotating, release the switch trigger
to avoid kinking or damaging the cable. Then slowly retract the cable from the drain pipe.
2. When you release the operation switch on the front handle and squeezing the switch trigger, the cable will rotate but not advance.
Hold the switch trigger for several seconds allowing the obstruction to wrap around the cable, if the cable stops the rotating, release
the switch trigger to avoid kinking or damaging the cable, then slowly retract the cable and pull the obstruction through the drain.
Once the obstruction is cleared, attempt to flush your toilet or run water through your drain to confirm that the water is flowing freely.
Meanwhile please be sure that the cable is cleared properly as described in the section of Cleaning the Drain Auger.
In case of obstruction or booked cornering of the cable, to retract the cable for a certain distance, then advance cable again,
repeatedly move cable forward and backward operation to dredge the pipe and move through the corners.
NOTE: Situation of pipe blockage are varied, it is necessary to lightly depress the switch trigger (low speed) to closely observe the
situation of the cable when using it. If it is distorted or blocked, stop the machine immediately and then take different operations
according to the actual situation. If the pipe can not be dredged, please ask professional for help. DO NOT force the operation and
cause unnecessary troubles.
CAUTION:
DO NOT force the delivery of the cable, otherwise the cable will be twisted, knotted or broken and cause serious injury.
DO NOT advance or retract the cable using the switch trigger unless the cable is in a drain pipe. When removing the cable from a
drain, remove it slowly to avoid “ Splash Back”!
Using the drain auger
To clean obstruction
6 Inch
To Next Page
Loading...
