Porsche 912 E - Distributor Drive Shaft Service

28
Ignition
REMOVING AND INSTALLING DISTRIBUTOR DRIVE SHAFT
1. Remove distributor drive shaft with puller.
2. Take out washer from under drive shaft.
3. Offset slot in top end of distributor drive
- 0
shaft should be at an angle of approx. 12
to longitudinal axis of engine. Larger slot
segment
faces inward.
28 - 8 Removing and Installing Distributor Drive Shaft
Set
cylinder 1 to TDC mark. White mark on fan
0
pulley must be opposite 0 mark on timing scale.
Printed in Germany