Parking 243
Warning!
Risk of accident when using the garage door
opener if persons, animals or objects are
within the range of movement of the equip-
ment that is being operated.
f When using the garage door opener, ensure
that no persons, animals or objects are within
the range of movement of the equipment that
is being operated.
f Observe the safety notes for the original hand-
held transmitter.
To operate the device in question
(e.g. garage door, gate to the property,
alarm system):
f Press the relevant button in keypad A.
Light-emitting diode B lights up during the
signal transfer.
Notes on operation
f Always use the garage door opener in the
direction of travel.
Otherwise, range restrictions cannot be ruled
out.
f Before selling the vehicle, delete the pro-
gramed signals in keypad A of the garage door
opener.
f Please read the instructions for the original
hand-held transmitter to find out whether the
original transmitter is equipped with fixed or
changeable code.
Deleting programed signals
(e.g., when selling the vehicle)
This process deletes the standard codes set at
the factory. Do not repeat the process if you pro-
gram further buttons
f Keep the two outer buttons of key pad A
pressed for approx. 20 seconds until light-
emitting diode B begins to flash.
All programed signals are deleted.
Assigning garage door opener signal to
key with fixed code system
1. Please follow the operating instructions for the
original hand-held transmitter.
2. The standard codes set at the factory must be
deleted before programming for the first time.
3. Point the original transmitter at the marked
position.
4. Press the button of the original hand-held trans-
mitter and the button to be allocated on the
keypad simultaneously (see illustration).
To Next Page
Loading...
Need help?
General
