58 Seats, Mirrors and Steering Wheel
Interior Mirror
Initial position – lever forward
Anti-dazzle setting – lever back
Note on operation
f When the interior mirror is being adjusted, anti-
dazzle lever A must point forward.
E - Light-emitting diodes (LED)
F - Button for automatic anti-dazzle operation
G - Light sensors
Automatic Anti-Dazzle Mirror
Sensors on the front and rear sides of the interior
mirror measure the incident light. The mirrors
automatically change to anti-dazzle position or
revert to their normal state, depending on the light
intensity.
Note on operation
The incident light in the area of light sensors G
must not be restricted (e.g. by stickers on the
windshield).
Switching off automatic anti-dazzle
operation
f Press button F.
Light-emitting diode E goes out.
Note on operation
Anti-dazzle operation switches off automatically,
if:
– Reverse gear is engaged or
– Interior lighting and/or
reading lights in the front are switched on.
Switching on automatic anti-dazzle
operation
f Press button F.
Light-emitting diode E lights up.
Warning!
Danger of injury. Electrolyte fluid can
emerge from broken mirror glass. This fluid
irritates the skin and eyes.
f If the electrolyte fluid should come into contact
with the skin or eyes, immediately rinse it off
with clean water.
See a doctor if necessary.
Risk of damage to paintwork and leather and
plastic parts, and clothing. Electrolyte fluid
can be removed only while it is still wet.
f Clean the affected parts with water.
To Next Page
Loading...
Need help?
General
