88 Windows and Sliding Roofs
The vehicle must be stationary in order to
store the end position of the roll-up sunblind.
The Panorama roof system and roll-up sunblind
must be closed.
1. Switch on ignition.
2. Press the rocker switch forward in closing
direction and hold in position.
The process for storing the end position
begins after approximately 10 seconds.
Press and hold the switch until the roll-up
sunblind has stopped moving completely.
The process takes a maximum of 45 seconds.
Start the storing process again if the switch
is released before the roll-up sunblind has
stopped moving completely.
Roll-up sunblind cleaning function
The vehicle must be stationary in order to activate
the roll-up sunblind cleaning function.
1. Switch on ignition.
2. Open the Panorama roof system completely.
3. Close the roll-up sunblind as far as possible.
4. Press and hold the rocker switch forward.
The roll-up sunblind starts to close after
3 seconds. Keep the rocker switch pressed
until the roll-up sunblind is closed fully.
5. Remove dirt (e.g. leaves).
To exit the cleaning function:
f Drive off. The roll-up sunblind opens
automatically.
or
Operate the Panorama roof system. The roll-up
sunblind opens automatically.
or
Open the roll-up sunblind with the rocker
switch.
Emergency Operation of Sliding/
Lifting Roof or Panorama Roof
System
If there are persons or animals in the movement
range of the sliding/lifting roof or Panorama roof
system, parts of the body could become trapped
or crushed.
f Make sure that nobody can be injured when
operating the sliding/lifting roof or Panorama
roof system.
Emergency closing after repeated
intervention from the force limiter
f Remove the obstruction.
f Repeatedly press or press and hold the switch
in closing direction until the sliding/
lifting roof or Panorama roof system closes
and stops in closed position.
Emergency operation if the roof drive
mechanism fails
If the sliding/lifting roof or Panorama roof system
is defective, it can be closed or opened manually
using a hexagon key.
f Before using emergency operation, check
whether the fuse has blown.
For information on checking the electric fuse:
f Please see the chapter “CHANGING FUSES” on
page 286.
1. Take the hexagon key A out of the closing
element in the instrument panel on the driver’s
side.
Roof Operation
To Next Page
Loading...
Need help?
General
